Have you been thinking about regrouting your flooring in Singapore? Perhaps, you have been noticing how unkempt and unmaintained your flooring looks, even though you cleaned it many times? Well, you do not have to worry since it is a normal thing to happen. You see, like most things, flooring tends to wear out over time. It happens that way because of the foot traffic it experiences. So, do not be too hard on yourself since it would not do good to you. What you should do instead is replace the gum grout of your marble floors.
Well, of course, like most household chores, grouting your floor by yourself is not an easy feat to do. More so, if you have never done it before. You probably are wondering what you need to do and what you need to avoid. So, to help you a hand, this article would discuss the dos and don’ts of grouting. That way, you would not commit any mistake in the future.
DOS
- Clean everything before grouting.
Cleaning your marble floor before placing gum grout helps to make the application last longer. So, make sure to remove the old grout first and use a brush to clean off the dirt and dander embedded inside.
- Remember to let it sit.
After mixing all the ingredients of your grouting, you should let it sit first, at least for ten to fifteen minutes. Upon doing this helps the mixture to be more efficient as a sealant for your flooring. However, if you notice the blend is too thick, you can add some water to make it thinner.
- Remove excess before caulking.
Before adding the acrylic sealant to your grout in Singapore, you should remove the excess grouting mixture first. That way, your flooring would look and feel so smooth. Well, to help you scrape off those, you can use a utility knife if you do not have a grouting spatula.
- Joint the flooring together.
Well, of course, while you are grouting your flooring, you should make sure you fill in its gap. You could do that by angling the grouting spatula at 45 degrees and push the mixture. Once done, remember to clean off the residue. That way, it would look evenly polished.
DON’TS
- Mixing it improperly.
No matter how expensive the grouting products you bought in Singapore, it would not work well if you do not mix it properly. Furthermore, adding the incorrect amount of water can also make the mixture less efficient and could make the output look botched. So, make sure to mix it well until it has a smooth and consistent texture.
- Uneven grouting application.
Similar to how you vacuum your carpet, grouting your flooring requires even attention. That way, it would not form any peaks or valleys that could hurt your feet when you walk barefoot. Besides, an uneven coating could harm the interior design of your home. So, as much as possible, spread the mixture in one direction at a time.
- Scrub too hard.
Another thing that most homeowners make when they DIY the grouting process is scrubbing too hard or using a lot of water. So, instead of using a hose to clean off the residue, you can use a sponge to dab the entire surface.
- Grouting at the wrong time.
Since timing is everything, you should know when to wipe off the tiles you grouted. You have to make sure that the mixture has all set up. That way, it would not become uneven or look blotched. So, if you can, wait for at least 24 to 72 hours before wiping the residue.
When does your floor need regrouting?
As mentioned before, timing is everything. So, do not only decide to start grouting your floor because you want to do it. You have to see if your flooring needs one. To give you some hint when you should, here are some signs below.
- Crumbling grout.
- Appear to stain or discolour
- Flooring becomes loose.
- Developing moulds
Make sure to take note of these signs and check out your flooring from time to time. Doing so would help you decide when you should do the regrouting process of your flooring.
What do you need when grouting?
Well, since you have a plan to do the grouting of your floor in Singapore, it would be a good idea to gather all of these items below. That way, you will be safe throughout the grouting process.
- Grouting brush. (Make sure it has a thin and soft bristle)
- Oxygen and chlorine bleach.
- Alkaline cleaner.
- Safety goggles.
- Rubber gloves.
- Microfibre towel.
- Face mask only if you cannot stand the smell of those chemicals.
- Stainless-steel basin.
Needs help regrouting your floor? Then, reach out to our regrouting services in Singapore!
At GroutPro Tech, our purpose is to provide you with the utmost care and attention to your flooring needs. That way, you would have a clean and fresh-looking floor. Furthermore, you would no longer have to be shy of inviting your friends to come over since your flooring would look spotless, even from afar. As we use the latest cleaning material possible, we can rest assured that your flooring would be sparkling clean in no time!
So, what are you waiting for? Give us a call + 65 96710521 and let us know where you are. That way, our staff could start regrouting your flooring in Singapore! Or if you want, you could also visit our website to find out more about what other services we can do for you.